Winston Industries PF56C Servisní příručka stáhnout pdf (Strana 170)

REPLACE VENT BLOCK (ITEM NO.

39)

Tools:

Slotted Screwdriver; Phillips Screwdriver

#2.

Procedure:

DANGER: Turn off electrical power and disconnect electrical power supply. If unit is

hardwired CIRCUIT BREAKER MUST BE OFF.

CAUTION:

Utilize care when removing muffler in Step 2. Muffler may contain very hot

water.

Remove

muffler

and place in sink.

Lift and remove vent back.

Remove

the seven (7) screws securing Danger Label panel and back panel on either left

or right hand side (servicer preference) and save for reuse. Remove back panel.

Remove weight from weight lifter.

Remove the four (4) screws securing vent block to vent assembly. Remove block, ball (if

NOTES:

Some

4-Head

and

6-Head

models utilize a stainless steel vent ball (located on vent block)

with weight to regulate pressure.

Each new vent block kit contains replacement screws and a vent block nut plate.

Servicer must use own discretion whether nut plate must be replaced. If nut plate

must be replaced,

remove the four (4) screws securing vent assembly to rear of fryer

and save for reuse. Remove vent assembly being careful not to apply tension to

vent solenoid wires. Remove defective nut plate and discard. Place new nut plate

on vent tube. Place vent assembly back onto rear of fryer making sure vent tube

protrudes through vent assembly at least

1/2"

(See Figure 35). Replace the four (4)

screws securing vent assembly to rear of fryer. If nut plate does not need replacing,

proceed to Step 7.

FIG.35

FIG. 35

WINSTON

LIT.6710/REV.0/9-91

applicable) and O-ring.

1 2 ... 165 166 167 168 169 170 171 172 173 174 175 ... 306 307

Komentáře k této Příručce

Žádné komentáře

Winston Industries PF56C Servisní příručka Strana 170

Komentáře k této Příručce

Související produkty a manuály pro Hluboké fritézy Winston Industries PF56C